6. SPECIAL OPERATIONS

In addition to regular operation, the following special operations will have to be performed regularly:

  • Supplying oil
  • Supplying cleaning fluid
  • Draining waste oil
  • Checking air and fluid pressure
  • Reading the oil pattern into the 'Liner Panel' software.
    •

    You also may have to:

  • Drain any air that has collected in the oil tubes
  • Replace the oil by a new type
  • Adjust the power of the air extractor unit
    •

    The following should never be done:

  • Clean or replace the air filter .
  • Clean the inside of the spraying compartment.
  • Clean the liquid and air orifices in the oil spray nozzles.

    • 6.1. Supplying Oil

    6.2. Supplying Cleaner Fluid

    6.3. Draining Waste Oil

    6.4. Checking Air and Fluid Pressure

    6.5. Reading the oil pattern into the 'Liner Panel' software.

    6.6. Draining Air from the Oil Tubes

    6.7. Replacing Oil by a New Type

    6.8. Adjusting the Power of the Air Extractor Unit

    6.9. Do Not Clean or Replace the Air Filter

    6.10. Do Not Clean the Inside of the Spraying Compartment.

    6.11. Do Not Clean the Liquid and Air Orifices in the Oil Spray Nozzles.